Looking for suggestions for small bore checking 0.25-4mm sort of range, predominantly for checking for burrs on cross holes and ensuring clean sharp edges. Customer does not allow chemical or thermal deburr so it is being done manually, with lots of back and forth between deburr section and inspection. Currently use a hawkeye borescope but was looking for more of a repeatable and visual system as inspection is picking up burrs that deburr are struggling to see.
Looking to see if others out there have something that might fit the bill.
0.25-4mm diameter about 50mm deep, is sort of the boundary we are currently looking at possibly deeper at a later date
submitted by /u/DeamonEngineer
[visit reddit] [comments]
Source link
