Reverse Engineering STL Part


Reverse Engineering STL Part

Hello fellow 3d scanning enthusiast,

I just scanned a part with the 3dmakerpro SEAL, and I’m pretty astonished by the outcome of the scan. It turned out much better than I expected. Now I have to remove some zits and blobs and define the edges a little better to print the part as good as possible.

I thought of taking measurements and modelling around the STL file, but that defeats the purpose of scanning I guess. I’m working with Mac and don’t have access to a reverse engineering software like QUICKSURFACE or Design X. I don’t know Meshmixer good enough, yet, and I’m completely new to FreeCAD.

What would you suggest how to go about this?

https://preview.redd.it/kzngjxy47g4e1.jpg?width=3666&format=pjpg&auto=webp&s=d558616541bc47d9169e8a2f47ec27f002407af7

https://preview.redd.it/uhrdfp367g4e1.png?width=2032&format=png&auto=webp&s=1ba7719b76c72162ff356c83a186f278cab2d466

https://preview.redd.it/rx02ks367g4e1.png?width=1966&format=png&auto=webp&s=ca24e14600e3cb583987a62e84c34881955dc2d7

submitted by /u/VegetarianTbone
[visit reddit] [comments]



Source link

Related Posts

About The Author

Add Comment