So I’m using a .5 mm x 20 mm renishaw stylus. The CMM is pretty much dedicated to a family of parts where we scan 16 diameters per section and there are 6-7 sections that get checked per part. 10 of the diameters are threaded holes. My question is; is it possible that after running through a few hundred parts can the stylus start wearing down? I’m seeing a deviation in parts that I checked before and know that they are good. So I’m not sure if the stylus is wearing down, or do I need to increase how often I calibrate the probe?
submitted by /u/Upbeat_Squirrel10
[visit reddit] [comments]
Source link
