I’m using a crysta apex with MCOSMOS version 5. I took a program that was running on a bright with Mcosmos version 4. The program takes points on the outer surface and then moves to an inner surface for more points. Both of these surfaces have their own profile callout. We are using best fit. My problem is the program ran fine on version 4. Using the program on version 5 cat1000 lags after a certain point. The CMM will have the surface done but cat1000 lags and half the points are missing and then cat1000 freezes. I have turned off the display for machine position, fixture, ect, thinking that maybe these were the issue. Any help would be appreciated.
submitted by /u/Upbeat_Squirrel10
[visit reddit] [comments]
Source link
