Does anyone know of any good books or videos for PC-DMIS?
I am used to polyworks for 10 years and polyworks is fantastic. It does probe compensations perfectly. PC-DMIS seems to be a mess and disorganized. No real feature tree and very glitchy. The Circle/intersect function is not working with a plane.
Then I think I got the right measurements but it is obvious the software did not do the proper compensation of the circle for the 6mm probe. Hole is almost exactly 6mm smaller than when I measure with calipers like it built the circles from the center of the 6mm probe.
I cant even imagine why a software would not compensate for the ball size properly.
My first goal was to find the centerline diameter of 3 holes in a circular pattern. It seems the hole centerpoints are correct so the centerline is correct, but it is bugging me the holes are about 6mm smaller than it should have measured.
submitted by /u/GrouchyTime
[visit reddit] [comments]
Source link
