Hi, I’m building a spin casting machine. These are some images from the design:
There are two disks that must be pressed against each other and rotate around the axis of the spindle.
The spindle is positioned at the top and pressure is provided by a toggle clamp at the bottom of the machine. The lower disk is separated from the square ram of the toggle clamp through a bearing.
The toggle clamp and spindle housing will be mounted with screws on the metal sheets that will be welded to the frame of the machine. These sheets are slightly bent and not machined.
My question is, how could I mount the spindle with the square ram, coaxial? How to measure their coaxiality? Should I weld the sheets to the frame without much care and then shimming the spindle housing and toggle clamp to align their axes?
submitted by /u/regulus_mj94
[visit reddit] [comments]
Source link
