One of the parts that my shop is quoting has a little less than Half a gear at on end that we need to machine. I am trying to figure out what gaging I need to Check it. Some googling led me t Go/Nogo spline gage but does that do everything? What should i be thinking about? any tips are welcome.
I googled AGMA 11 as well but didn’t quite understand what I was reading.
The details of the gear are below.
NUMBER OF TEETH, NOMINAL 26
NUMBER OF TEETH, ACTUAL (INCOMPLETE GEAR) 11
DIAMETRAL PITCH 20
PRESSURE ANGLE 20
MAJOR DIAMETER 1.500
PITCH DIAMETER 1.400
ROOT DIAMETER 1.276
ROOT FILLET RADIUS 0.022 MAX
QUALITY AGMA 11
submitted by /u/iusethisatworkk
[visit reddit] [comments]
Source link
