|
Hi, I’d like some recommendations on 3D scanners for relatively small objects (almost always <150 mm). My main use case is increasing the speed of 3D modeling and making difficult measurements easier to acquire, or preventing cases where measurement error starts to become additive. Cases in the below model I made were the placement of tapped holes in the recessed side panel, the angle of the ported face in the bottom. I’d say I’m pretty decent at reverse engineering 3D models but these features become tedious or difficult to do with manual measurement. Secondly is there a product with a workflow that assists with this sort of stuff in any way? I know software is an issue for a lot of consumer scanners. I’m not looking to extract a model I can work with from scans, more something I can pull into fusion, align a face to a plane, and use it as a reference when making sketches. For cost I don’t have a set range but lower is better and I’d wait a while for used prices to drop on some of the more expensive scanners. submitted by /u/Various_Scallion_883 |
