Bonus Tolerance question
Hopefully a pretty basic question. Some coworkers and I were debating on how bonus tolerance works.
On the drawing in question there is a true position callout of:
.010″ at MMC of a .015″ +/- .002″ hole.
I understand how to calculate bonus tolerance but where I’m lacking understanding is, if the hole measures at either .0129″ or .0171″, both of which would be out of spec, does bonus tolerance no longer apply? And therefore the position callout reverts back to .010″?
Hopefully that makes sense, thanks in advance!
submitted by /u/angerji
[visit reddit] [comments]
Source link
